The change is one of the most important parts of an automatic electric gun. This is considered the heart of an AEG because if it is defective or not maintained properly, the weapon is not expected, or worse, the entire box is mechbox or mechanism to ruin. For these reasons, it is essential to understand the functionality of the gears and spare parts and maintenance.
Typical weapon like an M16 Airsoft has 3 fields. The chamfer, track and field gear.
The bevel isconnected to the motor. And 'slightly conical in shape to be perpendicular to the engine. It has a different set of tiny teeth, which is then connected to the Spur Gear.
The Spur Gear is to turn the motor from the power bevel gear to the industry expands. The small group of teeth of the gear shift provides a much faster response for the industry.
The industry also has two sets of gear teeth. One set is for smaller teeth of the gear track connected. Otherto encompass not have a complete set of gear teeth. This part of the transmission acts as a catch and release the plunger. Reaches the piston, and pull back the spring behind the piston. And because the transmission is issued a full set of teeth of the piston pushes the air and get a small hole where you placed a BB.
These gears operate in harmony with the entire mechbox. It starts with the trigger, as it combines the flow of power from the engine(Most electric air weapons). The engine then turns the bevel gear wheel of his set of external teeth. The small group of teeth of gear track runs faster and so is the industry much faster transmission. The industry is gearing then does its job of pulling back the plunger to compress the spring behind it. The piston, when released, the compressed air into the room through a small opening in front of him a BB pellet pushes out of the barrel at a certain speed. This process isrepeated at a much faster rate.
Works well for this course, you should always be clean of dirt. After cleaning, should be lubricated to reduce friction and the likelihood of overheating. It is advisable to stop firing and give yourself time to cool down the gears when it's too hot. Gears, which are made of plastic tends to melt during prolonged use, while the metal to heat up faster, but tend to more power.
0 comments:
Post a Comment